sisterbeautysupply.com

The Way To Apply A Full Lace Entrance Wig

Lace Entrance Wig application with liquid adhesive

First issues first…PREPARATION…PREPARATION…PREPARATION!

-Collect your application merchandise and line then up for simple access. Put together your hair by wrapping, pin curling or braiding your individual hair.

-Clip back all the baby hairs in your unit to keep away from chopping them by mistake. By making use of fray block (non-obligatory) this may forestall your unit from fraying and likewise lengthen the life of your unit.

-Fastidiously lower additional lace around the perimeter of the wig to the place the hair is knotted, being cautious not to reduce into the newborn hairs. Take your time with this process, as you do not need to chop too much off. We recommend reducing a bit of at a time.

-Apply alcohol or cleanser with a make up sponge to cleanse your skin across the edges of your natural hairline. The goal is to take away all excess oils from your skin. We advocate a make up sponge VS the cotton ball, because the cotton ball will sometimes depart traces of the cotton in your hairline. Apply scalp protector to space to be bonded. Let dry.

-Place the lace wig on your head. Use an eyebrow pencil; flippantly hint the hairline of the wig onto your brow, this may make it easier to to apply your unit precisely where it looks most natural.

Utilizing an software brush to use adhesive just beyond your hairline as instructed by the lace wig adhesive manufacturer. As soon as the glue is prepared (this may depend on the glue type) position lace wig on your head with hairline rolled back. Starting at the center level of your forehead, bond wig to go by pressing down on one facet, then the other, using the end of a tail comb. Bond entrance hairline first for lace front wigs, then the nape for full lace wigs. Use the back finish of comb to press harder additional securing lace entrance wig onto hairline. Permit time for glue to fully cure/dry before styling. (Usually 24 hours)

Tie the edges of hair with a silk or satin scarf until glue has totally set / cured.

Utility with Adhesive/Tapes

-Prepare the lace wig, hair and pores and skin as previously talked about above.

-Reduce the tape into desired shapes and connect firmly around the perimeter of your unit.

-Position the unit on your head. Remove the backing of the tape in sections, a little bit at a time.
Ranging from the center of the forehead, firmly press tape into skin with a tail comb.

-Tie the sides of the hair with a silk or satin scarf till the adhesive has set.

-PLEASE NOTE:

If you’re new to this course of, please take your time; make sure to install your unit in a cool place to avoid sweating.

To attain a longer hold, mix the usage of liquid and tape adhesives. The tape helps preserve the lace by protecting it from frequent wear and tear. For tape/glue application, first apply glue to hairline, then apply tape to the front and nape of the wig. Press tape into wig firmly. When glue is ready, remove backing of tape and press the lace down into skin utilizing a tail comb.

Happy Putting in!

Find out more about lace wigs, see how Lace front are applied, and How they look on Clients! Visit lace wigs

Related blogs

Exit mobile version